Miele EVS 6114 Operating and Installation instructions - Page 33

Frequently Asked Questions Problem Possible cause and solution There is a film of oil on the glass lid and in the drawer. The oil in the vacuum pump has become extremely hot.  Clean the drawer and leave it to cool down for 1 hour before starting another vacuuming process.  When carrying out a number of consecutive vacuuming processes, wait a minimum of 2 minutes between each process to prevent the oil from overheating again.  If the fault occurs again, contact Miele Technical Service. The vacuuming process The required vacuum could not be achieved. is canceled after 2 min-  Switch the drawer off and back on again. utes. An acoustic tone  Start the vacuuming process again, selecting a dif- sounds and the  sym- ferent vacuum level if necessary. bol lights up red. After intensive use of the drawer, the oil in the vac- uum pump has severely overheated.  Leave the drawer to cool for an hour before start- ing another vacuuming process.  When carrying out a number of consecutive vacu- uming processes, wait a minimum of 2 minutes between each process to prevent the oil from overheating again. The vacuuming process The glass lid is not sitting evenly. There is an object, is canceled after 5 sec- e.g., the edge of a bag, or some soiling on the sur- onds. An acoustic tone face of the chamber seal. sounds and the  sym-  Remove the obstruction and/or the soiling. bol lights up red.  Close the glass lid and press it down lightly for ap- prox. 5 seconds. The chamber seal is not fitted correctly.  Press the chamber seal in all the way round to make sure it is fitted evenly. The chamber seal is damaged, e.g., cracks can be seen.  Contact Miele Technical Service to replace it. 33