Miele KM 5860 Operating and Installation manual - Page 51

Electrical connection ,CAUTION: Before installation or servicing, disconnect the power supply by either removing the fuse, shutting off the main power or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous and the manufacturer will not be held responsible. Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the rating label correspond with the household electrical supply. This data must correspond to prevent appliance damage. Consult an electrician if in doubt. Only operate the appliance after it has been installed into the countertop. Installer: Please leave these instructions with the consumer. Power supply ^ Be sure your electrical supply matches the data plate. The rating label is located on the underside of the appliance. The appliance is equipped with a flexible metal conduit encasing 3 wires ready for connection to a grounded power supply. It must be connected to a dedicated line through the use of an approved junction box. A disconnection incorporated in the fixed wiring must be provided. There must be an all-pole contact gap of at least 3 mm in the isolator switch (including switch, fuses and relays). Black wire: connect to L1 (hot) Red wire: connect to L2 (hot) Green wire: connect to GND (ground) KM 5840 208/240 V, 60 Hz, 40 A fuse rating KM 5860 280/240 V, 60 Hz, 50 A fuse rating KM 5880 208 V, 60 Hz, 60 A fuse rating 240 V, 60 Hz, 50 A fuse rating Be sure the power outlet is accessible after installation. For further information, see the wiring diagram provided with the appliance. , WARNING: THIS APPLIANCE MUST BE GROUNDED! 51