Miele KS 7793 D Operating instructions/Installation instructions - Page 51

Switching off Demo mode, Resetting the settings to their default settings, Information - model

Page 51 highlights

Selecting additional settings Switching off Demo mode  Demo mode  allows the refrigeration appliance to be presented in the showroom without the cooling system being switched on. Do not activate this setting for domestic use. If Demo mode has been switched on as a default setting,  will show on the status display.  Tap .  Tap .  Swipe left or right until  is shown in the middle.  Tap . After Demo mode  has been switched off, the refrigeration appliance shuts down and must be switched on again. Resetting the settings to their default settings  All settings made on the refrigeration appliance will be reset to default settings (for settings; see "Guide to the appliance").  Tap .  Swipe left or right until  is shown in the middle.  Tap .  will appear on the display.  Touch OK. The refrigeration appliance shuts down and must be switched on again. Information  Appliance data (model identifier and serial number) is shown on the display. Keep this appliance data to hand; you will need it: - When integrating the refrigeration appliance into your WiFi network (see "Selecting additional settings - Miele@home"). - When reporting an appliance fault to Miele Customer Service (see "Service"). - When retrieving information from the EPREL database (see "Service"). Carbon-filter change indicator  After inserting the carbon filter (optional accessory), you must activate the carbon-filter change indicator  in Settings mode . The carbon-filter change indicator  on the status display will remind you to replace the carbon filter approx. every 6 months (see "Cleaning and care - Replacing the carbon filters"). Cleaning mode  Cleaning mode  makes it easier to clean the refrigerator section (see "Cleaning and care"). The interior lighting remains switched on, even though the refrigerator section is switched off. The audible signal will stop and the symbols on the display will also go out. If Cleaning mode  is switched on, this will be indicated on the status display. 51

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88

Selecting additional settings
51
Switching off Demo mode 
Demo mode 
allows the refrigeration
appliance to be presented in the show-
room without the cooling system being
switched on. Do not activate this setting
for domestic use.
If Demo mode has been switched on
as a default setting,
 will show on the
status display.
Tap 
.
Tap 
.
Swipe left or right until 
is shown in
the middle.
Tap 
.
After Demo mode 
has been switched
off, the refrigeration appliance shuts
down and must be switched on again.
Resetting the settings to their default
settings 
All settings made on the refrigeration
appliance will be reset to default set-
tings (for settings; see “Guide to the ap-
pliance”).
Tap 
.
Swipe left or right until 
is shown in
the middle.
Tap 
.
 will appear on the display.
Touch
OK
.
The refrigeration appliance shuts down
and must be switched on again.
Information 
Appliance data (model identifier and
serial number) is shown on the display.
Keep this appliance data to hand; you
will need it:
-
When integrating the refrigeration ap-
pliance into your WiFi network (see
“Selecting additional settings –
Miele@home”).
-
When reporting an appliance fault to
Miele Customer Service (see “Ser-
vice”).
-
When retrieving information from the
EPREL database (see “Service”).
Carbon-filter change indicator 
After inserting the carbon filter (optional
accessory), you must activate the car-
bon-filter change indicator 
in Set-
tings mode 
.
The carbon-filter change indicator 
on the status display will remind you
to replace the carbon filter approx. ev-
ery 6 months (see “Cleaning and care
– Replacing the carbon filters”).
Cleaning mode 
Cleaning mode 
makes it easier to
clean the refrigerator section (see
“Cleaning and care”). The interior
lighting remains switched on, even
though the refrigerator section is
switched off. The audible signal will
stop and the symbols on the display
will also go out.
If Cleaning mode 
is switched on,
this will be indicated on the status dis-
play.