Milwaukee Tool M18 FUEL 1/2" Hammer Drill/Driver Service Parts List - Page 2

Bit Holder on M12™ Products, Bit Holder on M18™ Products, 16-3697 BIT HOLDER ACCESSORY, PART NO.,

Get Milwaukee Tool M18 FUEL 1/2inch Hammer Drill/Driver PDF manuals and user guides View all Milwaukee Tool M18 FUEL 1/2" Hammer Drill/Driver manuals
Add to My Manuals
Save this manual to your list of manuals

Page 2 highlights

Position ground ring terminal behind lug of gearcase. Route ground wire through wire trap channel as shown. The view is shown with forward/reverse shuttle removed. Bit Holder on M12™ Products a b c Bit Holder on M18™ Products d b 49-16-3697 BIT HOLDER (ACCESSORY) FIG. PART NO. DESCRIPTION OF PART a 06-82-3008 6-32 x 12.7mm Pan Hd. Phillips Screw (For M12™ Tools) b Bit Holder c Adapter (For M12™ Tools) d 06-82-2500 6-32 x 7mm Pan Hd. Phillips Screw (For M18™ Tools) FOR M18™ TOOLS, DISCARD KIT PARTS 'A' AND 'C'. 1. Install LED light as shown. 2. Insert light board into housing cavity. 3. Place battery connector block into corresponding housing cavity. LED Light Light Board Battery Connector Block FIG. 62 SERVICE NOTES A clean, dry surface is essential for proper performance for any adhesive system. The area intended for application of any adhesive label or nameplate must be prepared by cleaning with isopropyl alcohol. The solvent is to be applied with a clean, lint free applicator and the surface allowed to dry before applying the label or nameplate.

  • 1
  • 2
  • 3
FOR M18™ TOOLS, DISCARD KIT PARTS ‘A’ AND ‘C’.
Bit Holder on M12™ Products
Bit Holder on M18™ Products
a
b
c
d
b
49-16-3697 BIT HOLDER (ACCESSORY)
FIG.
PART NO.
DESCRIPTION OF PART
a
06-82-3008
6-32 x 12.7mm Pan Hd. Phillips Screw (For M12™ Tools)
b
---------------
Bit Holder
c
---------------
Adapter (For M12™ Tools)
d
06-82-2500
6-32 x 7mm Pan Hd. Phillips Screw (For M18™ Tools)
Position ground ring terminal behind lug of
gearcase. Route ground wire through wire
trap channel as shown. The view is shown
with forward/reverse shuttle removed.
1. Install LED light as shown.
2. Insert light board into housing cavity.
3. Place battery connector block into
corresponding housing cavity.
LED Light
Light Board
Battery Connector Block
FIG.
SERVICE NOTES
62
A clean, dry surface is essential for proper performance
for any adhesive system. The area intended for
application of any adhesive label or nameplate must be
prepared by cleaning with isopropyl alcohol. The
solvent is to be applied with a clean, lint free applicator
and the surface allowed to dry before applying the
label or nameplate.