Motorola 4652 Getting Started Guide - Page 28
Navigating through the Console Screens, Change a toggle value Yes/No, On/Off
View all Motorola 4652 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
5-28 Getting Started Guide Launch your terminal emulation software and configure the communications software for the values shown in the table below. These are the default communication parameters that the Netopia 4652 uses. Parameter Suggested Value Terminal type PC: ANSI-BBS Mac: ANSI, VT-100, or VT-200 Data bits 8 Parity None Stop bits 1 Speed 9600 - 57600 bits per second Flow Control None Note: The router firmware contains an autobaud detection feature. If you are at any screen on the serial console, you can change your baud rate and press Return (HyperTerminal for the PC requires a disconnect). The new baud rate is displayed at the bottom of the screen. Navigating through the Console Screens Use your keyboard to navigate the Netopia 4652's configuration screens, enter and edit information, and make choices. The following table lists the keys to use to navigate through the console screens. To... Use These Keys... Move through selectable items in a screen or pop-up menu Set a change to a selected item or open a pop-up menu of options for a selected item like entering an upgrade key Change a toggle value (Yes/No, On/Off) Restore an entry or toggle value to its previous value Move one item up Move one item down Display a dump of the device event log Display a dump of the WAN event log Refresh the screen Up, Down, Left, and Right Arrow Return or Enter Tab Esc Up arrow or Control + K Down arrow or Control + O Control + E Control + F Control + L