Motorola L403 User Guide - Page 28

Advanced Settings - cordless phone

Get Motorola L403 PDF manuals and user guides View all Motorola L403 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

6.7 Registration Up to 5 handsets can be registered to one base. The original handset is pre-registered to use. Additional handsets must be registered to the base before you can use them. To register an additional handset, 1. Press P and , to select SETUP HS. 2. Press P and , to select REGISTRATION. P , 3. Press and to select YES or NO. P 4. Select YES and press to enter the registration procedure as below: 1. Place the unregistered cordless handset on the charger. v 2. Press and hold for 4 seconds on base. v 3. Release once IN USE LED is flashing. 4. A confirmation tone is generated if registration is successful. HANDSET X is displayed where X denotes the number of handsets and the phone goes back to idle. 7. Advanced Settings 7.1 Set the Dial Mode The default dialing mode is suitable for your country and network operator. It is unlikely that you should need to change this setting unless advised to do so. 1. 2. 3. 4. Press Press Press Press P P P P and , , to select and to save. to select SETUP BS. DIAL MODE. to select TONE or PULSE. * NOTE If pulse mode is selected, press to switch from pulse to tone dialing temporarily when dialing out. After the call is ended, the dial mode will change back to pulse. 7.2 Set the Flash Time The default flash time is 600MS. It is unlikely that you should need to change this setting unless advised to do so. 1. Press P and , to select SETUP BS. 2. Press P and , to select FLASH TIME. 28 Advanced Settings

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
28
Advanced Settings
6.7
Registration
Up to 5 handsets can be registered to one base. The original
handset is pre-registered to use. Additional handsets must
be registered to the base before you can use them.
To register an additional handset,
1.
Press
P
and
,
to select
SETUP HS
.
2.
Press
P
and
,
to select
REGISTRATION
.
3.
Press
P
and
,
to select
YES
or
NO
.
4.
Select
YES
and press
P
to enter the registration
procedure as below:
1. Place the unregistered cordless handset on the
charger.
2. Press and hold
v
for 4 seconds on base.
3. Release
v
once IN USE LED is flashing.
4. A confirmation tone is generated if registration is
successful.
HANDSET X
is displayed where
X
denotes
the number of handsets and the phone goes back to
idle.
7.
Advanced Settings
7.1
Set the Dial Mode
The default dialing mode is suitable for your country and
network operator. It is unlikely that you should need to
change this setting unless advised to do so.
1.
Press
P
and
,
to select
SETUP BS
.
2.
Press
P
to select
DIAL MODE
.
3.
Press
P
and
,
to select
TONE
or
PULSE
.
4.
Press
P
to save.
NOTE
If pulse mode is selected, press
*
to switch from pulse to
tone dialing temporarily when dialing out. After the call is
ended, the dial mode will change back to pulse.
7.2
Set the Flash Time
The default flash time is 600MS. It is unlikely that you should
need to change this setting unless advised to do so.
1.
Press
P
and
,
to select
SETUP BS
.
2.
Press
P
and
,
to select
FLASH TIME
.