Motorola mT2a User Guide - Page 25

Installation Steps Configure mT2 EthernetXD Switch Initial configuration should be done connected to one of the Ethernet ports on the upstream side of the switch. Login using a serial console connection, telnet or HTTP. Note the default IP address of the unit if using a network login for the initial configuration. Default IP: 192.168.1.3 Enter these commands at the system prompt: Login with default username and password Username: Password: admin Assign IP address to unit ip config ip-address 192.168.20.2 mask 255.255.255.0 gateway 192.168.20.1 Enable Ethernet ports interface Ethernet enable eth2 system reboot Enable all High Speed DSL ports interface dsl enable port(1-25) Configure all High Speed DSL ports interface dsl config port(1-25) max-down 100 max-up 10 Enable remote Ethernet port 1 of each WallPlate interface remote enable port(1-25)-1 Motorola, Inc. 549453-001-00-a Page 25 of 51