NEC E321 MultiSync LCD5710-2-AV : WMK-3257 accessory guide - Page 2

Warning

Page 2 highlights

Note: Read entire instruction sheet before you start installation and assembly. WARNING • Do not begin to install this product until you have read and understood the instructions and warnings contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call customer care at 1-800-865-2112. • This product should only be installed by someone of good mechanical aptitude, has experience with basic building construction, and fully understands these instructions. • Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components. • Never exceed the UL Listed Maximum Load Capacity of 150 lb (68 kg). • If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an "edge to edge" stud finder is highly recommended. • Always use an assistant or mechanical lifting equipment to safely lift and position equipment. • Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding power. • This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury. • This product was designed and intended to be mounted to the following supporting surfaces checked below with the hardware included in this product as specified in the installation sheet. To mount this product to an alternative supporting surface, contact customer care at 1 800 865-2112. • This product was designed to be installed on the following wall construction only; WALL CONSTRUCTION x Wood Stud x Wood Beam x Solid Concrete x Cinder Block Metal Stud Brick Other or unsure? ADDITIONAL HARDWARE REQUIRED None None None None Do not attach except with Peerless accessory kit for metal studs; Contact Customer Service for Peerless accessory kit for metal studs. (not evaluated by UL) Contact Customer Service (not evaluated by UL) Contact Customer Service Table of Contents Parts List ...3 Installation to Double Wood Stud Wall ...4 Installation to Solid Concrete or Cinder Block ...5 Installing Tilt Brackets ...6 Installing Flat Panel Screen to Wall Plate ...7 For customer care call (800) 865-2112 or (708) 865-8870. 2 of 7 ISSUED: 03-26-10 SHEET #: 125-9106-3 08-04-10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7

2 of 7
ISSUED: 03-26-10
SHEET #: 125-9106-3
08-04-10
Note:
Read entire instruction sheet before you start installation and assembly.
Table of Contents
Parts List
..............................................................................................................................................................................
3
Installation to Double Wood Stud Wall
..................................................................................................................................
4
Installation to Solid Concrete or Cinder Block
.......................................................................................................................
5
Installing Tilt Brackets
...........................................................................................................................................................
6
Installing Flat Panel Screen to Wall Plate
.............................................................................................................................
7
For customer care call (800) 865-2112 or (708) 865-8870.
Do not begin to install this product until you have read and understood the instructions and warnings contained in this
Installation Sheet. If you have any questions regarding any of the instructions or warnings, please call customer care
at 1-800-865-2112.
This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
Never exceed the UL Listed Maximum Load Capacity of 150 lb (68 kg).
If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an
"edge to edge" stud finder is highly recommended.
Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specified in the installation sheet. To mount this product to an alternative support-
ing surface, contact customer care at 1 800 865-2112.
This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
ADDITIONAL HARDWARE REQUIRED
x
Wood Stud
None
x
Wood Beam
None
x
Solid Concrete
None
x
Cinder Block
None
Metal Stud
Do not attach except with Peerless accessory kit for metal studs;
Contact Customer Service for Peerless accessory kit for metal studs.
Brick
Contact Customer Service (not evaluated by UL)
Other or unsure?
Contact Customer Service
WARNING
(not evaluated by UL)