NEC GT5000 GT5000/GT6000/GT6000R UM - Page 15
Press to display the Keystone Correction 3D Reform screen. - case
View all NEC GT5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
1. Introduction 10. UNDO Press to return the adjustments and settings to the previous condition. While pressing and holding CTL, pressing this button clears the entire menus or adjustment/setting screen. At this time the adjustments/settings are stored in memory except the items on the setting screen with "OK" and "Cancel" buttons such as the Menu and the Setup screen. 11. CANCEL Press to exit the menu. Press this button with CTL to return to the previous menu without closing adjustment/setting screen while the menus appear. This feature allows you to adjust or set several items concurrently. 12. INFO Displays the "Source Information" or "Projector Information" window. This button toggles between these two windows. While pressing and holding CTL, pressing this button stores lens position settings. 13. TEST Press to display the test pattern. Pressing this button sequentially selects test patterns. 14. HELP Provides online help. 22. AMPLITUDE (G) Service personnel only. When the test pattern is displayed, while pressing and holding CTL, pressing this button displays a green test pattern. 23. ENTRY LIST (B) Press to display the Entry List screen. Pressing and holding CTL and then ENTRY LIST buttons simultaneously, enters a signal in the Entry List when you are not displaying a test pattern. When the test pattern is displayed, while pressing and holding CTL, pressing this button displays a blue test pattern. 24. FOCUS (+/-) While pressing and holding CTL, pressing this button allows you to adjust the lens focus. 25. MAGNIFY/ZOOM (+/-) Magnify the size of a target portion. While pressing and holding CTL, pressing this button allows you to zoom the lens in and out. 26. CTL Used in conjunction with other buttons, similar to a shift key on a computer. PRO M ADJUST DWEHIFTE BAL. IMAGE 2 IBCCTURE ENATDEDRRESSMENU + 15. PIXEL Displays the Position/Clock screen to adjust the clock and phase. BS - ON POWER 16. AUTO (RGB only) Press to adjust Position-H/V and Pixel Clock for an optimal picture. 17. POSITION Press to display the Position screen; press again to display the Blanking screen. While pressing and holding CTL, pressing this button displays the Lens Shift adjustment screen. 27 28 27. Remote Jack Connect your remote cable here for wired operation. OFF 18. MUTE SOUND Turns off the sound for a short period of time. Press again to restore the sound. 28. Infrared Transmitter Direct the remote control toward the remote sensor on the projector cabinet. 19. MUTE OSD Press to turn off the on-screen display. Press again to restore the on-screen display. NOTE: You can also turn off the on-screen display forcibly by pressing and holding CTL and then pressing MUTE OSD (Forced On-Screen Mute Mode) ; doing this again restores it. In this case any adjustment will still change the projector's memory settings. This mode is available even when input is switched to another or the power is turned off the main power. 20. MUTE PICTURE Press to turn off the picture for a short period of time. Press again to restore the picture. 21. KEYSTONE (R) Press to display the Keystone Correction (3D Reform) screen. This button toggles between "Cornerstone" and "Keystone". When the test pattern is displayed, while pressing and holding CTL, pressing this button displays a red test pattern. NOTE: Pressing and holding this button for a minimum of two seconds will reset 3D Reform correction setting values to zero. 1-11