NEC LCD175VXM-BK MultiSync LCD175VX+_195VX+_175VXM - Page 5
Quick Start - multisync +
UPC - 805736014655
View all NEC LCD175VXM-BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Quick Start To unfold stand, follow these instructions: 1. Place monitor face down on a non-abrasive surface (Figure 1). 2. Pull the stand holding the monitor with the other hand until the stand clicks (Figure 2). NOTE: Handle with care when pulling the stand. NOTE: Reverse process to re-pack monitor. Figure 1 Figure 2 To attach the MultiSync LCD monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. For the PC or MAC with DVI digital output: Connect the DVI signal cable (not included) to the connector of the display card in your system (Figure A.1). Tighten all screws. For the PC with Analog output: Connect the 15-pin mini D-SUB signal cable to the connector of the display card in your system (Figure A.2). Tighten all screws. For the MAC: Connect the MultiSync Macintosh cable adapter (not included) to the computer, then attach the 15-pin mini D-SUB signal cable to the MultiSync Macintosh cable adapter (Figure A.3). Tighten all screws. NOTE: To obtain the MultiSync Macintosh cable adapter, call NEC Display Solutions of America, Inc. at (800) 632-4662. Figure A.1 Figure A.2 Figure A.3 DVI Signal Cable (not included) Macintosh Cable Adapter (not included) Note: Some Macintosh systems do not require a Macintosh Cable Adapter