NEC NP300 Users Manual - Page 13
(3) Part Names of the Projector, Front/Top, Rear, Introduction - filter
UPC - 805736026634
View all NEC NP300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Part Names of the Projector Front/Top Zoom Lever (→ page 27) Focus Ring (→ page 27) Remote sensor (→ page 8) Lens Lens Cap FOCUS MENU SELECT EXIT STATLUASMP ENTER AUTOADJ. SOURCE 1. Introduction Controls (→ page 5) Security chain opening Attach an anti-theft device. The security chain opening accepts security wires or chains up to 0.18 inch/ 4.6 mm in diameter. Built-in Security Slot ( )* Ventilation (inlet) / Filter Cover (→ page 70) Adjustable Tilt Foot Lever (→ page 26) Adjustable Tilt Foot (→ page 26) * This security slot supports the MicroSaver ® Security System. Rear Ventilation (inlet) / Filter Cover (→ page 70) Terminal Panel (→ page 6) SELECT MENU ENTER SOURCE AUTOADJ. EXIT STATLUASMP Lamp Cover (→ page 72) FOCUS Monaural Speaker (7W) Ventilation (outlet) Heated air is exhausted from here. Spacer (black rubber) To fine-adjust the height of the rear foot, remove the spacer and rotate the rear foot to the desired height. Rear Foot (→ page 26) AC Input Connect the supplied power cable's two-pin plug here, and plug the other end into an active wall outlet. (→ page 21) Main Power Switch When you plug the supplied power cable into an active wall outlet and turn on the Main Power, the POWER indicator turns orange and the projector is in standby mode. (→ page 22,32)