NEC NP610 NP310 : user's manual - Page 82

5. Using On-Screen Menu Selecting Communication Speed [COMMUNICATION SPEED] This feature sets the baud rate of the PC Control port (D-Sub 9P). It supports data rates from 4800 to 19200 bps. The default is 19200 bps. Select the appropriate baud rate for your equipment to be connected (depending on the equipment, a lower baud rate may be recommended for long cable runs). NOTE: Your selected communication speed will not be affected even when [RESET] is done from the menu. Setting ID to the Projector [CONTROL ID] (Available only when the optional remote control NP02RC is used) You can operate multiple projectors separately and independently with the single remote control that has the CONTROL ID function. If you assign the same ID to all the projectors, you can conveniently operate all the projectors together using the single remote control. To do so, you have to assign an ID number to each projector. CONTROL ID NUMBER Select a number from 1 to 254 you wish to assign to your projector. CONTROL ID Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID setting. OFF ON POWER NOTE: COMPUTER 1 2 3 AUTO ADJ. • Selecting [ON] for [CONTROL ID] will make the remote control supplied with the projector inoperable. The buttons on the projector VIDEO S-VIDEO COMPONENT HDMI VIEWER NETWORK PIP cabinet can be used. Neither can you operate the projector by using the optional remote control NP01RC that does not has the CONTROL ID function. 1 2 3 • Your setting will not be affected even when [RESET] is done from the menu. 4 5 6 7 8 9 • Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Control ID 0 CLEAR ID. MENU EXIT Assigning or Changing the Control ID 1. Turn on the projector. 2. Press the ID SET button on the remote control (NP02RC). The CONTROL ID screen will be displayed. L-CLICK ENTER R-CLICK VOLUME MAGNIFY PAGE UP DOWN PICTURE LAMP MODE ASPECT AV-MUTE 3D REFORM FREEZE FOCUS ID SET LENS SHIFT /ZOOM HELP ID If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the projector cannot be operated with the current remote control ID, the [INACTIVE] will be displayed. To operate the inactive projector, assign the control ID used for the projector by using the following procedure (Step 3). OFF ON POWER 3. Press one of numeric keypad buttons while pressing and holding the ID SET button on the1 remote control COMPUTER 2 3 AUTO ADJ. (NP02RC). VIDEO S-VIDEO COMPONENT HDMI VIEWER NETWORK PIP Example: 1 2 3 To assign "3", press the "3" button on the remote control. 4 5 6 No ID means that all the projectors can be operated together with a single remote control. To set "No ID", enter "000" or press the CLEAR button. 7 ID MENU 8 9 0 CLEAR EXIT TIP: The range of IDs is from 1 to 254. 4. Release the ID SET button. The updated CONTROL ID screen will be displayed. NOTE: The IDs can be cleared in a few days after the batteries are run down or removed. L-CLICK ENTER R-CLICK VOLUME MAGNIFY PAGE UP DOWN PICTURE LAMP MODE ASPECT AV-MUTE 3D REFORM FREEZE FOCUS ID SET LENS SHIFT /ZOOM HELP ID 73