NEC PX-50M5A 5000W - Page 16

Connecting Your PC Or Macintosh Computer Connecting your PC or Macintosh computer to your PlasmaSync 5000W will enable you to display your computer's screen image for an impressive presentation. The PlasmaSync 5000W supports the signals described on page 50. To connect to a PC, Macintosh or compatible graphics adapter, simply: 1. Turn off the power to your PlasmaSync 5000W and computer. 2. If your PC does not support XGA/SVGA/VGA you will need to install an XGA/SVGA/VGA graphics board. Consult your computer's owner's manual for your XGA/SVGA/ VGA configuration. If you need to install a new board, see the manual that comes with your new graphics board for installation instructions. 3. The PlasmaSync 5000W provides signal compatibility up to VESA 1280‫ן‬1024@85Hz (SXGA). However, some signals are only displayed in the normal mode (5:4). See page 50 for more details. 4. Use the signal cable that's supplied to connect your PC or Macintosh computer to the PlasmaSync 5000W. For Macintosh, use the supplied monitor adapter to connect to your computer's video port. 5. Turn on the PlasmaSync 5000W and the computer. 6. If the PlasmaSync 5000W goes blank after a period of inactivity, it may be caused by a screen saver installed on the computer you've connected to the PlasmaSync 5000W. When using a Macintosh with the PlasmaSync 5000W, the following four display standards are supported using the included Macintosh adapter : 13" fixed mode 16" fixed mode 19" fixed mode 21" fixed mode The 19" fixed mode is recommended for the PlasmaSync 5000W. Connecting Your Document Camera You can connect your PlasmaSync 5000W to a document camera. To do so, simply: 1. Turn off the power to your PlasmaSync 5000W and document camera. 2. Use a standard video cable to connect your document camera to the Video input on your PlasmaSync 5000W. 3. Turn on the PlasmaSync 5000W and the document camera. Note: Refer to your document camera's owner's manual for more information about your camera's video output requirements. Connecting Your VCR Or Laser Disc Player Use common RCA cables (not provided) to connect your VCR or laser disc player to your PlasmaSync 5000W. To make these connections, simply: 1. Turn off the power to your PlasmaSync 5000W and VCR or laser disc player. 2. Connect one end of your RCA cable to the video output connector on the back of your VCR or laser disc player, connect the other end to the Video input on your PlasmaSync 5000W. Use standard RCA audio patch cords to connect the audio from your VCR or laser disc player to your PlasmaSync 5000W (if your VCR or laser disc player has this capability). Be careful to keep your right and left channel connections correct for stereo sound. 3. Turn on the PlasmaSync 5000W and the VCR or laser disc player. Note: Refer to your VCR or laser disc player owner's manual for more information about your equipment's video output requirements. Connecting Your DVD Player You can connect your PlasmaSync 5000W to a DVD player. To do so, simply: 1. Turn off the power to your PlasmaSync 5000W and DVD player. 2. Use a standard video cable to connect your DVD player to the Y, Cb, and Cr inputs on your PlasmaSync 5000W. Or use the DVD-player's S-Video output. Use a standard S-Video cable to connect to the S-Video input on the PlasmaSync 5000W. 3. Turn on the PlasmaSync 5000W and the DVD player. 9