NEC PX-60XM5A 60XM5 speaker manual - Page 3

English Attaching speakers to a plasma monitor The speakers are divided into a right (R) and left (L) speaker. When attaching the speakers, be sure to check the labels located on the rear of the speakers as well as the markings (R/L) written on the attachment plates. 1 Remove the protective tape from the cushions and then attach the cushions to the sides of the speakers in the locations indicated in the diagram below. 2 Attaching the attachment pieces to the locations shown in the drawing of the plasma monitor with screws (M5 × 12 mm) (8 locations). Check the marks on the attachment pieces (TL, TR, BL, BR) and the plasma monitor attachment locations. Cushions 3 Loosely screwing the screws (M5 × 12 mm) into place on the top attachment pieces (2 locations). Note To install the plasma monitor on a wall, first attach the attachment pieces to the plasma monitor then install it on the wall. After installing the plasma monitor on the wall, it may be impossible to tighten the screws on the attachment pieces. 4 1 Attaching the screws (M5 × 12 mm) that have been loosely screwed into place on the hooks on top of the speakers. 2 Loosely screw the screws (M5 × 12 mm) into place with the screw holes on the attachment pieces on the bottom aligned with the holes in the hooks on the bottom of the speakers. 3