NEC VT540 User Manual - Page 20
Settings for Monitor Mode, Examples of DIP switch setting - manual
UPC - 050927226151
View all NEC VT540 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
When using a Macintosh computer with the projector, set the DIP switches of the supplied pin adapter according to your resolution. After setting, restart your Macintosh computer. See the following pages for setting of the DIP switches. • When using with a Macintosh, SVGA(800ן600 :VT440)/ XGA(1024ן768 : VT540) is recommended if your Macintosh supports this mode. • When using with a Macintosh PowerBook, output may not be set to 800ן600 unless "mirroring" is off on your PowerBook. Refer to owner's manual supplied with your Macintosh computer for mirroring. NOTE: A Video Adapter cable manufactured by Apple Computer is needed for a PowerBook which does not have a mini D-Sub 15-pin connector. Settings for Monitor Mode Number of DIP switch Resolution 1 13" multi-scan mode /16"-13" ON 17" multi-scan mode /19"-13" ON 21" multi-scan mode /21"-13" ON 13" fixed mode /640x480 ON VGA/SVGA mode 16" fixed mode /832x624 19" fixed mode /1024x768 21" fixed mode /1152x870 ON 23 ON ON ON ON ON ON ON ON ON ON 456 ON ON ON ON ON ON ON NOTE: For settings other than display modes supported by your Macintosh and the projector, use of the DIP switch may bounce an image slightly or may display nothing. If this happens, set the DIP switch to the 13" fixed mode and then restart your Macintosh. After that, restore to a displayable mode and then restart the Macintosh again. Make sure that the projector and your Macintosh are connected with the pin adapter and the supplied signal cable (mini DSub 15-pin connector) and then restart your Macintosh. Examples of DIP switch setting 17" multi-scan mode VGA/SVGA mode ON ON 19" fixed mode ON 1 2 34 5 6 1 2 34 5 6 1 2 34 5 6 NOTE: Refer to your computer's owner's manual for more information about your computer's video output requirements and any special identification or configuring your projector's image and monitor may require. E-20