Nady 401X QUAD Manual - Page 4

a. Instrument Connection using the WGT instrument transmitter - wht

Get Nady 401X QUAD PDF manuals and user guides View all Nady 401X QUAD manuals
Add to My Manuals
Save this manual to your list of manuals

Page 4 highlights

Operation a. Instrument Connection (using the WGT instrument transmitter) Insert an audio cord with a ¼" mono phone plug in the AF OUTPUT JACK (8) on the rear panel of the receiver. Plug the other end of the cord into amplifier, effect or mixing board. Adjust the VOLUME CONTROL (6) on the 401X QUAD clockwise to about ¾ rotation until the volume level is comfortable for your application. This setting is roughly equivalent to direct instrument cord connection. Turning the volume up to maximum will provide 4dB gain over a cord. b. Microphone Connection (using the WLT transmitter with either a headset or lavalier microphone or the WHT handheld microphone transmitter) Insert an audio cord with a ¼" mono phone plug in the AF OUTPUT JACK (8) on the rear panel of the receiver. Plug the other end of the cord into amplifier, effect or mixing board. Adjust the VOLUME CONTROL (6) on the 401X QUAD clockwise to about ½ MAX and adjust the volume control until the volume level is optimal. If the volume control is set too high, you may overload your mixer or amp. Since your 401X QUAD is comprised of four separate and independent XLR output channels, it can be used with either one, two, three or four channels operating. Simply turn your mixer volume control of any channel which you are not using to minimum. If the mix line out is used, just turn down the 401X QUAD receiver's volume controls. 16V AC/DC Adapter Antennas 5 34 67 8 9 10 11 4

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
4
a. Instrument Connection (using the WGT instrument transmitter)
Insert an audio cord with a ¼” mono phone plug in the
AF OUTPUT JACK (8)
on the rear panel of
the receiver. Plug the other end of the cord into amplifier, effect or mixing board. Adjust the
VOLUME CONTROL (6)
on the 401X QUAD clockwise to about ¾ rotation until the volume level is
comfortable for your application. This setting is roughly equivalent to direct instrument cord
connection. Turning the volume up to maximum will provide 4dB gain over a cord.
b. Microphone Connection (using the WLT transmitter with either a headset
or lavalier microphone or the WHT handheld microphone transmitter)
Insert an audio cord with a ¼” mono phone plug in the
AF OUTPUT JACK (8)
on the rear panel of
the receiver. Plug the other end of the cord into amplifier, effect or mixing board. Adjust the
VOLUME CONTROL (6)
on the 401X QUAD clockwise to about ½ MAX and adjust the volume
control until the volume level is optimal. If the volume control is set too high, you may overload
your mixer or amp.
Since your 401X QUAD is comprised of four separate and independent XLR output channels, it
can be used with either one, two, three or four channels operating. Simply turn your mixer volume
control of any channel which you are not using to minimum. If the mix line out is used, just turn
down the 401X QUAD receiver’s volume controls.
16V AC/DC Adapter
Antennas
5
8
9
10
11
3
6
4
7
OPERATION