Nady CX-22SW Manual - Page 5

CONTROLS AND CONNECTIONS 115V/60Hz 230V/50Hz XLR BALANCE D PIN 1 GND PIN 2 HI PIN 3 LO PHONE UNBAL AC IN FUSE 0.5A HIGH 12 13 9 R CHANNEL OUTPUT 11 LOW INPUT 10 SUB L CHANNEL WOOFER 11 HIGH OUTPUT 11 LOW INPUT 10 NADY SYSTEMS, Inc. Emeryville, CA, USA Made in Taiwan REAR PANEL 9. FUSE COMPARTMENT: Replace with only the same type fuse (0.5A/250V). If it blows continuously, do not use the unit until it has been serviced by qualified personnel. 10. STEREO INPUT CONNECTORS: Connect your L/R stereo input signal to either the balanced XLR or the unbalanced 1/4" phone jacks. 11. OUTPUT CONNECTORS: Connect to your amplifiers via these unbalanced 1/4" phone jacks. 12. AC VOLTAGE SELECTOR SWITCH: Before plugging in the power cord, check to see that the unit is set for the proper voltage for your area:~115V (60Hz) or ~230V (50Hz). 13. POWER CONNECTOR The IEC jack is used to connect the power cord to the AC Power Source. (Caution: Do not remove the center grounding pin.) SPECIFICATIONS Crossover Type Stereo 2 ways + Subwoofer Crossover Range Subwoofer: 50 - 250Hz, -24/10dB Low/High : 250-6000Hz, -24/10dB Filter Type (Slope 2nd order, 12dB/Octave Inputs Type Balanced XLR and unbalanced 1/4" Impedance 100KΩ Outputs Type Unbalanced 1/4" Impedance 220 Ω Low Cut Filters 30Hz/ - 3dB, 12dB/Octave Frequency Response 20Hz - 25KHz +/-1dB Total Harmonic Distortion (THD) + Noise 0.05 % S/N Ratio 95 dB Fuse 0.5 A/ 250V, 5mm glass type Dimensions 19'' x 1.73'' x 5.9'' (483 X 44 X 150mm) Weight 4.4 lbs. (2.2 Kg) Specifications and design subject to change without prior notice for improvement purposes 5