Naxa NHS-2005 NHS-2005 English Manual - Page 7
Tuning
View all Naxa NHS-2005 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
8. During playback, press and hold TUNING/SKIP/SEARCH buttons to search through the current track forward or backward. Note: • Pairing mode is canceled about 1.5 minutes. • The above are generic steps to pair a BLUETOOTH device, for more specific instructions on BLUETOOTH connectivity for your device, please consult your manufacturer's manual. RE-CONNECT TO THE BLUETOOTH AUDIO SOURCE DEVICE If the device is already paired with the Naxa, but became unconnected even with both Bluetooth devices turned on. You can re-connect them by following steps: 1. Press and hold the PAIR button on the unit or on the remote to re-link the audio source device. The Bluetooth indicator will blink for about 1.5 minutes for connecting. 2. Select Naxa on the audio source device for connecting. Bluetooth indicator will turn to solid blue if the Naxa and the device have been re-connected successfully. EQ EFFECTS During playback, press EQ button on the remote repeatedly to cycle through the EQ options; when your desired EQ effect shows on the screen, release the button. FM RADIO TUNING THE FM RADIO 1. Power on the unit, switch to FM (RADIO) mode by pressing MODE button repeatedly. 2. Press the TUNING/SKIP/SEARCH buttons on the remote to fine tune radio station. Press and hold the TUNING/SKIP/SEARCH buttons on the remote to auto search radio station forward or backward respectively (When an available station will be found, the unit will broadcast it immediately and the searching will be stopped). During auto searching, press the TUNING/SKIP/SEARCH buttons on the remote to stop the searching. 3. At radio mode, it is possible to access the frequency via numeric buttons on the remote control. For example, press buttons 8, 9 and 8 to get to 89.8 MHz. STORING YOUR FAVORITE RADIO STATION 1. During playback, press the MEM button on the remote for storing the current station until a memory cell number flashes on the screen. 2. Use the CH+ or CH- buttons on the remote to select the corresponding memory cell for storing the station. 3. Confirm your selection by pressing the MEM button on the remote. Page 6