Naxa NPB-252 NPB-252 English Manual - Page 7

CD OPERATION CD PLAYER OPERATION 1. Set the Function Switch(CD/OFF/Radio)(#16) to the "CD" position. 2. Open the CD Door (#8). Place an audio CD with its label side upward in the CD compartment and close the CD Door. 3. After a few seconds, the total number of tracks on the CD will appear in the CD LCD Display (#9). 4. Press the PLAY/PAUSE Button (13#) and the CD will start playing from the first track. 5. Adjust the Volume Control (#2) to obtain the desired sound level from the Speakers (#17). 6. To suspend playing, press the CD PAUSE Button (#13). The LCD Display will flash. To resume playing, press the CD PLAY Button again. 7. You can choose to play your favorite track directly by pressing the F.F Button(#14)/Rew Button (#12) skip forward or skip backward. The LCD Display (#9) will indicate the correct track number selected. 8. To repeat playing a particular track, press the REPEAT Button (#3) once. 9. To repeat playing the entire CD,, press the REPEAT Button (#3)twice. 10. To stop playing, press the CD STOP Button (#4). 11. When you wish to turn off the CD Player, set the Function Switch(CD/OFF/Radio) (#16) to the "OFF" position. MP3 PLAYER OPERATION 1. PLAY/PAUSE Press PLAY/PAUSE button(#13) one time play MP3 and press PLAY/PAUSE button(#13) two times to suspend. 2. you can choose to play your favorite track directly by pressing the F.F Button(#14)/Rew Button (#12)to skip forward or skip backward.The LCD Display(#9) Will indicate the correct track number selected. 3. To repeat playing a particular track, press the REPEAT Button (#3) once. The Repeat Indicator in the CD Track Display will flash. 4. To repeat playing the entire CD,, press the REPEAT Button (#3) twice. 5. To stop playing, press the STOP Button (#4) CD/MP3 PROGRAMMED PLAY This function allows the tracks to be played in a programmed sequence. 1. Under CD stop condition, press the PROG+10 Button (#5). The LCD Display (#9) will display "01" 2. Press the F.F Button(#14) to select the song to be programmed. 3. Press the PROG+10 Button (#5) again to store selection. The LCD Display (#9) will advance to "02". 4. Press the Rew Button (#12) to select the next song to be programmed and press the PROG. Button to store selection. 5. For CD/CD-R/CD-RW play,you may repeat steps #2 - #3 to program as many as 20 tracks. If you attempt to program more than 20 tracks, the LCD Display (#9) will revert to "01" and the old entry will be overwritten by the current new entry! 6. Press STOP Button (#4) to end programming and return to normal play mode. 7. To check the programmed tracks, press PROG+10 Button (#5) continuous to show all the programmed songs. The LCD Display (#9) will display the program number first and then followed by the flashing track number. 8. Press PLAY/PAUSE Button (#13) to begin programmed play. The first track in program will appear in the LCD Display (#9) . 9. To cancel programmed play, press the STOP Button (#4). 10. As long as the unit remains on and the CD Door (#8) is not opened, you can resume programmed play any time by pressing the PROG+10 Button (#5) and then PLAY/PAUSE Button (#13) in stop condition. E-6