Netgear CM1150V User Manual - Page 9

Voice Cable Modem Viewed from top to bottom, the back panel contains the following components: • Reset button. Pressing the Reset button resets your cable modem. If the Reset button is pressed for at least seven seconds, the Power LED blinks green and your cable modem returns to its factory settings. • Ethernet ports 1-4. For installation and activation, connect a computer to Ethernet port 1. After you install your cable modem and activate your Internet service, you can disconnect your computer and connect a router to Ethernet port 1. Note Your cable modem comes with plugs that cover Ethernet ports 2, 3 and 4. For more information about Ethernet ports 2, 3, and 4, visit netgear.com/support/product/CM1150V. • Tel 1 and 2 ports. Connect your phone line to the Tel 1 port. Note The Tel 2 port works only for a two-phone-line subscription. • Coaxial cable port. Connect the cable port to a cable wall outlet. • Power On/Off button. Press the Power On/Off button to provide power to your cable modem. • DC power connector. Connect the power adapter that came in the product package to the DC power connector. Label The cable modem label shows the login information, MAC address, and serial number. Figure 4. Cable modem label System Requirements You need the following to install your cable modem: • Compatible operating system: - Windows 10 - Windows 8 - Windows 7 Hardware Setup 9