Netgear DS106 DS104 Installation Guide - Page 7
Vista RJ-45 Network Ports with Built-in LEDs, Rear Panel - power adapter
View all Netgear DS106 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Vista RJ-45 Network Ports with Built-in LEDs The front panel of the Model DS104 hub provides four vista RJ-45 network ports (six on the Model DS106 hub, eight on the Model DS108 hub, 16 on the Model DS116 hub). These standard RJ-45 connectors accept two-pair or fourpair Category 5 unshielded twisted pair (UTP) copper wiring (only two pairs are used). The RJ-45 connector uses an 8-pin interface. Two LEDs are positioned at the top corners of each RJ-45 connector. The left indicator is the 100 Mbps Link/Receive LED, and the right indicator is the 10 Mbps Link/Receive LED. The illustration shows the Model DS116 Link/Receive LEDs. The LEDs for the Model DS104, Model DS106, and Model DS108 hubs are identical. The table that follows describes the LEDs for all three models. vista RJ-45 network ports 100Mbps LED 10Mbps LED 8152FB LED Status On Blinking Description Link (Good Connection) RX (Receive Data) Rear Panel The rear panels of the DS100 Series hubs are identical. Each has a ground clip and a receptacle for the power adapter. Rear Panel of the Model DS104, Model DS106, Model DS108, and Model DS116 Hub Ground clip 5 Vdc 800 mA - + Power receptacle 9092FB Model DS104/DS106/DS108/DS116 Dual Speed Hub Installation Guide