Netgear EN108 EN104 Installation Guide - Page 5

LEDs The table below describes the activity of the LEDs. Label Pwr (Power) Col (Collision) Link (located on the top left corner of each vista 10BASE-T port) Rx (located on the top right corner of each vista 10BASE-T port) Active (for BNC) Rx (for BNC) Active (for AUI) Rx (for AUI) Color Activity Description Green Amber Green On Blinking On Power is supplied to the hub. Data collision is occurring on the network. Note that occasional collisions are normal. The link between this port and the connected device is good. Green Blinking There is incoming data on the port. Green On The link between the BNC port and the connected device is good. Green Blinking There is incoming data on the BNC port. Green On The link between the AUI port and the connected device is good. Green Blinking There is incoming data on the AUI port. Normal/Uplink Push Button The Normal/Uplink push button allows you to select Normal (MDI-X) wiring for direct PC connection. The push button also allows you to select Uplink (MDI) wiring for connection to a hub or a switch through port 4 on the Model EN104 hub, port 8 on the Model EN108 hub, or port 16 on the Model EN116 hub. This uplink configuration eliminates the need to use a crossover cable. The other 10BASE-T ports are permanently configured for normal wiring for connection to a PC. Model EN104/EN108/EN116 Ethernet Hub Installation Guide