Home » Netgear Manuals » Wireless » Netgear EX5000 » Manual Viewer

Netgear EX5000 User Manual - Page 47

Factory Default Settings

Add to My Manuals
Save this manual to your list of manuals

Page 47 highlights

AC1200 WiFi Range Extender Factory Default Settings To reset the extender to factory default settings, you can use the Reset button on the side panel or you can log in and click the onscreen RESET button. For more information, see Return the Extender To Its Factory Default Settings on page 22. The following table shows the factory default settings. Table 2. Factory default settings Feature Smart Setup WiFi communication WiFi network name (SSID) Security Transmission speed Country/region Operating mode Data rate in the 2.4 GHz band Data rate in the 5 GHz band DHCP Default Settings Enabled Enabled NETGEAR_EXT Disabled Auto1 Varies by region 802.11a/b/g/n/ac 54/145/300 Mbps 54/145/300/433/867 Mbps Client enabled 1 Maximum WiFi signal rate (IEEE Standard 802.11). Actual throughput can vary. Network conditions and environmental factors, including volume of network traffic, building materials and construction, and network overhead lower actual data throughput rate. Technical and Environmental Specifications The following table shows the technical and environmental specifications. Factory Settings and Technical 47 Specifications User Manual

Section	Page
Contents	3
1. Overview	5
Meet Your Extender	6
LEDs	6
Buttons	7
When to Use Your Extender	7
How the Extender Works	7
2. Get Started	9
Install the WiFi Extender	10
Place the Extender and Apply Power	10
Connect to an Existing WiFi Network	10
Connect with WPS	10
Connect with the NETGEAR Installation Assistant	12
Find the Best Location	13
Log In to the Extender After Installation	13
Run Smart Setup Installation	14
3. Maintain and Monitor the Extender	15
Change the Extender admin User Name and Password	16
Turn Password Protection Off and On	17
Recover a Forgotten User Name or Password	17
Automatically Adjust for Daylight Saving Time	18
Manually Set the Extender Clock	19
Back Up and Manage the Extender Configuration	20
Back Up the Configuration Settings	20
Restore the Configuration Settings	21
Return the Extender To Its Factory Default Settings	22
Use the Reset Button	22
Log In and Reset the Extender to Factory Settings	22
Update the Extender Firmware	23
Check for New Firmware and Update the Extender	24
Manually Upload Firmware to the Extender	24
4. Extender Network Settings	26
View Connected Devices	27
Boost Your Video Streaming with FastLane Technology	27
View WiFi Settings	29
Change the WiFi Network Name	29
Turn Off the SSID Broadcast to Create a Hidden Network	30
Disable or Enable the WiFi Radios	31
Change the WiFi Speed	32
Use WPS to Add a Computer to the Extender’s WiFi Network	33
Use WPS with the Push Button Method	33
Use WPS with the PIN Method	34
Deny Access to a Computer or WiFi Device	35
Set Up an Access Schedule	36
Change the Extender’s Device Name	37
Set Up the Extender to Use a Static IP Address	38
Use the Extender with MAC Filtering or Access Control	39
5. FAQs and Troubleshooting	41
FAQs	42
Cannot Connect to the Extender	42
Cannot Join a WiFi Network and Receive an Error Message	43
Cannot Access mywifiext.net	43
Find Extender's IP Address	44
6. Factory Settings and Technical Specifications	46
Factory Default Settings	47