Netgear FS526T FS726T User Manual - Page 16
System Menu, System> Switch Status - reset
View all Netgear FS526T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Smart Switch Series Software Manual There is a Help Menu in the top of right side of screen. Click the help to read the full Help Menu. On some pages, there is a Help button. If you click that button, you will go to the part of the Help Menu that discusses that page. Within the various browser interface pages, there are several buttons that you can use. Their names and functions are below: Browse: Refresh: Apply: Add: Delete: Factory Reset: Help: Locates a certain path for a desired file. Pulls that screen's data from current values on the system Submits change request to system and refreshes screen data Add new entries to table information and refreshes screen data Deletes selected entries from table and refreshes screen data Restore the system factory default value. Goes to relevant section of Help Menu System Menu There are 4 options available in the system menu: • Switch Status • IP Access List • Setup • Password System> Switch Status Page The Switch Status page displays the port settings for both 10/100 Mbps and 10/100/1000 Mbps ports. To configure the ports, go to the Switch> Port Configuration page. • ID: The port number on the switch • Speed: Indicates the communication mode set for the port. The default setting for all ports is Auto-negotiation (Auto). The possible entries are Auto-negotiation (Auto), 10 Mbps half duplex (10M Half), 10 Mbps full duplex (10M Full), 100 Mbps half duplex (100M Half), 100 Mbps full duplex (100M Full), or Disable. 4-2 Web-Based Management Interface July 2005