Netgear FVL328 FVL328 Reference Manual - Page 28
Estart, Network, Correct, Sequence, Firewall, Warning, Enter
UPC - 606449025811
View all Netgear FVL328 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Model FVL328 ProSafe High-Speed VPN Firewall Reference Manual Revision 2 2. RESTART YOUR NETWORK IN THE CORRECT SEQUENCE Warning: Failure to restart your network in the correct sequence could prevent you from connecting to the Internet. a. First, turn on the broadband modem and wait 2 minutes. b. Now, turn on your firewall. c. Last, turn on your computer. Note: If software usually logs you in to the Internet, do not run that software, or cancel it if it starts automatically. d. Check the status lights and verify the following: • Power: The power light goes on when your turn the firewall on. • Test: The test light turns on, then goes off after less than a minute. • Local: A Local light on the router is lit. If no Local lights are lit, check that the Ethernet cable connecting the powered on computer to the router is securely attached at both ends. • Internet: The Internet light on the firewall is lit. If the Internet light is not lit, make sure the Ethernet cable is securely attached to the firewall Internet port and the powered on modem. 3. LOG IN TO THE FIREWALL a. From your PC, launch your Internet browser. Because you are not yet connected to the Internet, your browser will display a page not found message. b. Connect to the firewall by typing http://192.168.0.1 in the address field of Internet Explorer or Netscape® Navigator and clicking Enter. Figure 3-4: Log in to the firewall 3-4 Connecting the FVL328 to the Internet May 2004, 202-10030-02