Netgear GS748TR GS748TR Hardware manual - Page 24
Step 4: Connecting Devices to the Switch, Step 5: Installing an SFP GBIC Module, Use Category 5
UPC - 606449054552
View all Netgear GS748TR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
GS700TR Series Hardware Installation Guide Step 4: Connecting Devices to the Switch The following procedure describes how to connect PCs to the switch's RJ-45 ports. The NETGEAR Smart Switch contains Auto Uplink™ technology, which allows the attaching of devices using either straight-through or crossover cables. Figure 4-2 Connect each PC to an RJ-45 network port on the Switch front panel (Figure 4-2 ). Use Category 5 (Cat5) Unshielded Twisted-Pair (UTP) cable terminated with an RJ-45 connector to make these connections. Note: Ethernet specifications limit the cable length between the switch and the attached device to 100 m (328 ft.). Step 5: Installing an SFP GBIC Module The following procedure describes how to install an SFP Gigabit Ethernet module in the switch's Gigabit module bay. Standard SFP GBIC modules are sold separately from the Smart Switch. If an SFP GBIC module is not being installed at this time, skip this procedure. To install an SFP GBIC module: 4-16 v1.0, December 2007 Installation