Netgear GSM5212P GSM5212P/GSM7212P/GSM7212F/GSM7224P Administration Manual - Page 318

19. Switch Stacks 19 This chapter describes the concepts and recommended operating procedures to manage NETGEAR stackable managed switches running release 4.x.x.x or newer. This chapter includes the following topics: • Switch Stack Management and Connectivity • The Stack Master and Stack Members on page 319 • Install and Power-up a Stack on page 321 • Switch Firmware on page 322 • Configure a Stacking Port as an Ethernet Port on page 324 • Stack Switches Using 10G Fiber on page 327 • Add, Remove, or Replace a Stack Member on page 330 • Switch Stack Configuration Files on page 332 • Preconfigure a Switch on page 333 • Renumber Stack Members on page 334 • Move the Stack Master to a Different Unit on page 336 Switch Stack Management and Connectivity You manage the switch stack through the stack master. You cannot manage stack members on an individual basis. To access the stack master, use either a serial connection to the switch master's console port, or a Telnet connection to the IP address of the stack. You can use these methods to manage switch stacks: • Web Management Interface. • CLI (over a serial connection). • A network management application through SNMP. Chapter 19. Switch Stacks | 318