Netgear GSM7228PS 7200 Series Managed Switch CLI Refernce Manual for Software - Page 254

ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3 prefixes keyword, the and pair becomes the prefix, and the command displays the routes to the addresses that match that prefix. Use the parameter to specify the protocol that installed the routes. The value for can be connected, ospf, rip, or static. Use the all parameter to display all routes including best and non-best routes. If you do not use the all parameter, the command only displays the best route. Note: If you use the connected keyword for , the all option is not available because there are no best or non-best connected routes. Format Modes show ip route [{ [] | { [longer-prefixes] [] | } [all] | all}] • Privileged EXEC • User EXEC Term Route Codes Definition The key for the routing protocol codes that might appear in the routing table output. The show ip route command displays the routing tables in the following format: Code IP-Address/Mask [Preference/Metric] via Next-Hop, Route-Timestamp, Interface The columns for the routing table display the following information: Term Definition Code The codes for the routing protocols that created the routes. IP-Address/Mask Preference The IP-Address and mask of the destination network corresponding to this route. The administrative distance associated with this route. Routes with low values are preferred over routes with higher values. Metric The cost associated with this route. via Next-Hop The outgoing router IP address to use when forwarding traffic to the next router (if any) in the path toward the destination. Route-Timestamp The last updated time for dynamic routes. The format of Route-Timestamp will be • Days:Hours:Minutes if days > = 1 • Hours:Minutes:Seconds if days < 1 Interface The outgoing router interface to use when forwarding traffic to the next destination. For reject routes, the next hop interface would be Null0 interface. Routing Commands v1.0, May 2010 4-17