Netgear GSM7228PS 7200 Series Managed Switch CLI Refernce Manual for Software - Page 295

ProSafe 7200 Managed Switches CLI Manual, Software Version 8.0.3 (listed below). The currently supported values are: domain, echo, ftp, ftpdata, http, smtp, snmp, telnet, tftp, www. Each of these translates into its equivalent port number, which is used as both the start and end of a port range. To specify the match condition as a numeric value, one layer 4 port number is required. The port number is an integer from 0 to 65535. Default Format Mode none match srcl4port { | } Class-Map Config Ipv6-Class-Map Config DiffServ Policy Commands Use the DiffServ policy commands to specify traffic conditioning actions, such as policing and marking, to apply to traffic classes Use the policy commands to associate a traffic class that you define by using the class command set with one or more QoS policy attributes. Assign the class/policy association to an interface to form a service. Specify the policy name when you create the policy. Each traffic class defines a particular treatment for packets that match the class definition. You can associate multiple traffic classes with a single policy. When a packet satisfies the conditions of more than one class, preference is based on the order in which you add the classes to the policy. The first class you add has the highest precedence. This set of commands consists of policy creation/deletion, class addition/removal, and individual policy attributes. Note: The only way to remove an individual policy attribute from a class instance within a policy is to remove the class instance and re-add it to the policy. The values associated with an existing policy attribute can be changed without removing the class instance. The CLI command root is policy-map. Quality of Service (QoS) Commands v1.0, May 2010 6-19