Netgear M4100-D12G Hardware Installation Guide - Page 24
Troubleshooting, Troubleshooting Chart
View all Netgear M4100-D12G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
3. Troubleshooting 3 Troubleshooting Chart The following table lists symptoms, causes, and solutions to possible problems. Table 3. Troubleshooting chart Problem Cause Solution Power LED is off. No power is received. Check the power cord connections for the switch at the switch and the connected device. Make sure that all cables used are correct and comply with Ethernet specifications. Link LED is off or intermittent. Port connection is not working. • Check the crimp on the connectors. Make sure that the plug is fully inserted and locked into the port at both the switch and the connecting device. • Make sure that all cables used are correct and comply with Ethernet specifications. See Appendix A. • Check for a defective adapter card, cable, or port by testing it in an alternate environment where all products are functioning. Slow file transfer or there is performance degradation. Half- or full-duplex setting on • Make sure that the attached device is set to the switch and the connected autonegotiate. device are not the same. • Check the system message log. A segment or device is not recognized as part of the network. One or more devices are not Verify that the cabling is correct. Be sure that all properly connected, or cabling connectors are securely positioned in the does not meet Ethernet required ports. Equipment might have been guidelines. accidentally disconnected. ACT LED blinks continuously A network loop (redundant on all connected ports and the path) has been created. network is disabled. Break the loop by ensuring that there is only one path from any networked device to any other networked device. 24