Netgear M5300-52G Web Management User Guide - Page 133

ProSafe M5300 Switch GARP Port Configuration Note: It can take up to 10 seconds for GARP configuration changes to take effect. To display the GARP Port Configuration page, click Switching VLAN  Advanced  GARP Port Configuration. To configure the per-interface GARP settings: 1. Select the check box associated with each Interface to configure, or select the check box in the header row to apply the same settings to all interfaces. 2. Use Port GVRP Mode to choose the GARP VLAN Registration Protocol administrative mode for the port by selecting enable or disable from the dropdown list. If you select disable, the protocol will not be active and the Join Time, Leave Time and Leave All Time will have no effect. The factory default is disable. 3. Use Port GMRP Mode to choose the GARP Multicast Registration Protocol administrative mode for the port by selecting enable or disable from the dropdown list. If you select disable, the protocol will not be active, and Join Time, Leave Time and Leave All Time have no effect. The factory default is disable. 4. Use Join Time (centiseconds) to specify the time between the transmission of GARP PDUs registering (or re-registering) membership for a VLAN or multicast group in centiseconds. Enter a number between 10 and 100 (0.1 to 1.0 seconds). The factory default is 20 centiseconds (0.2 seconds). An instance of this timer exists for each GARP participant for each port. 5. Use Leave Time (centiseconds) to specify the time to wait after receiving an unregister request for a VLAN or multicast group before deleting the associated entry, in centiseconds. This allows time for another station to assert registration for the same attribute in order to maintain uninterrupted service. Enter a number between 20 and 600 (0.2 to 6.0 seconds). The factory default is 60 centiseconds (0.6 seconds). An instance of this timer exists for each GARP participant for each port. Configuring Switching Information 133