Netgear RP614 RP614v3 Setup Manual - Page 16

NETGEAR Router Setup Manual 3RZHU 7HVW ,QWHUQHW /$1 Figure 3-4: Verify the connections according to the status lights on the router d. Check the router status lights to verify the following: • Power: The power light should turn solid green. If it does not, see "Troubleshooting Tips" on page 3-6. • Test: The test light should be off. The test light blinks when the router is first turned on then goes off. If after 2 minutes it is still on, see the Troubleshooting Tips below. • Internet: The Internet port light should be lit. If not, make sure the Ethernet cable is securely attached to the router Internet port and the modem, and the modem is powered on. • LAN: A LAN light should be lit. Green indicates your computer is communicating at 100 Mbps; yellow indicates 10 Mbps. If a LAN light is not lit, check that the Ethernet cable from the computer to the router is securely attached at both ends, and that the computer is turned on. Use the Smart Wizard to Configure Your Router For DSL customers, if your Internet service provider had you install software logs you in to the Internet, do not run that software. If such software automatically starts when you open a browser, you may need to go to the Internet Explorer Tools menu, Internet Options, Connections tab page where you can select "Never dial a connection." 1. From the Ethernet connected computer you just set up, open a browser such as Internet Explorer or Netscape® Navigator. 3-4 Connecting the Router to the Internet August 2004