Netgear UTM9S UTM9S User Manual - Page 448
Table 116., Detailed Status screen fields continued, The WAN mode can be Single Port, Load Balancing - vdsl
View all Netgear UTM9S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 448 highlights
ProSecure Unified Threat Management (UTM) Appliance Table 116. Detailed Status screen fields (continued) Item Subnet Mask Description The subnet mask for this port. If the VLAN is not enabled on this port, the subnet mask is the default LAN IP subnet mask (255.255.255.0). For information about configuring VLAN profiles, see Configure a VLAN Profile on page 98. DHCP Status The status can be either DHCP Enabled or DHCP Disabled. For information about enabling DHCP for this port, see Configure a VLAN Profile on page 98. WAN Info and xDSL information in SLOT-1 Info or SLOT-2 Info Note: For the UTM9S only: DSL information is shown in SLOT-1 Info or SLOT-2 Info section, depending on the slot in which the xDLS module is installed. All other fields that are shown in the SLOT-1 Info or SLOT-2 Info section are also shown in the WAN Info sections. The following fields are shown for each of the WAN ports and for the slot in which the xDSL module is installed: WAN Mode The WAN mode can be Single Port, Load Balancing, or Auto Rollover. For information about configuring the WAN mode, see Configure the WAN Mode on page 75. UTM9S only: Card Type The configuration of the xDSL module: VDSL or ADSL. UTM9S only: Daughter Card The type of supported annex on the xDLS module: Annex A or Annex B (VDSL_ANNEXA, VDSL_ANNEXB, ADSL_ANNEXA, or ADSL_ANNEXB). UTM9S only: Firmware Version WAN State NAT The firmware on the xDSL module. The WAN state can be either UP or DOWN, depending on whether the port is connected to the Internet and whether the port is enabled. For information about connecting WAN ports, see Chapter 3, Manually Configuring Internet and WAN Settings. The NAT state can be either Enabled or Disabled, depending on whether NAT is enabled (see Configure Network Address Translation (All Models) on page 77) or classical routing is enabled (see Configure Classical Routing (All Models) on page 77). Connection Type The connection type can be Static IP, DHCP, PPPoE, or PPTP, depending on whether the WAN address is obtained dynamically through a DHCP server or assigned statically by you. For information about connection types, see Manually Configure the Internet Connection on page 71. Connection State The connection state can be either Connected or Not Connected, depending on whether the WAN port is physically connected to a modem or router. For information about connecting a WAN port, see the ProSecure Unified Threat Management UTM Installation Guide. WAN Connection Type The detected type of Internet connection that is used on this port. The WAN connection type can be DSL, ADSL, CableModem, T1, or T3. Upload Connection Speed The maximum upload speed that is provided by your ISP. Download Connection The maximum download speed that is provided by your ISP. Speed Monitoring System Access and Performance 448