Netgear WAG311 WAG311 Installation Guide - Page 15
Installation Guide for the NETGEAR Dual Band Wireless PCI Adapter WAG311 - software version 1 3
View all Netgear WAG311 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Installation Guide for the NETGEAR Dual Band Wireless PCI Adapter WAG311 Table 1-1. A Road Map for How to Get There From Here If I Want To ... ? What Do I Do? Connect to the 1. Activate my Internet over my wireless link wireless and verify my network. network connection. 2. Open an Internet browser such as Internet Explorer or Netscape Navigator. What's Needed? How Do I? 1. An active Internet connection like those from cable or DSL service providers. 2. A wireless network connected to the cable or DSL Internet To configure your WAG311 in Infrastructure Mode, see "Basic Setup" on page 2-1, and locate the section for your version of Windows. service through a cable/DSL router as illustrated in "Connect to an Access Point in Infrastructure Mode" on page 3-3. For assistance with configuring the TCP/IP Internet software on a PC, see "Preparing Your Computers for TCP/IP Networking" on page C-1 or refer 3. TCP/IP Internet networking to the PC Networking Tutorial on software installed and the NETGEAR Dual Band configured on my PC Wireless PCI Adapter WAG311 according to the requirements Resource CD (SW-10015-01) of the Internet service provider and the Help information 4. A browser like Internet provided in the Windows system Explorer or Netscape you are using. Navigator. . Introduction 1-5