Netgear WGT624 WGT624v4 Setup Manual - Page 16

Router Setup Manual Check the router status lights to verify correct router operation. If the Power light does not turn solid blue within 2 minutes after turning the router on, reset the router according to the instructions in "Restoring the Default Configuration and Password" on page 2-6. To Verify Basic Functioning After you turn on power to the router, the following sequence of events should occur: 1. When power is first applied, verify that the Power light is on (see "The Front of the Router" on page 1-2 for an illustration). 2. Verify that the Test light lights within a few seconds, indicating that the self-test procedure is running. 3. After approximately 1 minute, verify that: a. The Test light turned off. b. The LAN port lights are lit for any local ports that are connected. If a port's light is lit, a link has been established to the connected device. If a LAN port is connected to a 100 Mbps device, verify that the port's light is green. If the port is 10 Mbps, the light will be amber. c. The Internet port is connected and its light is lit. If the router connects to the Internet, the Internet port's light is green. Otherwise, it is amber. d. The Wireless port light is lit. Power Light Not On If the Power and other lights are off, check the following: • Make sure that the power cord is properly connected to your router and that the power supply adapter is properly connected to a functioning power outlet. • Check that you are using the power adapter supplied by NETGEAR for this product. If the error persists, you have a hardware problem and should contact technical support. 2-2 Troubleshooting v1.0, April 2007