Netgear WGT624v1 WGT624v1 Reference Manual - Page 30
Log in to the wireless router., or Netscape® Navigator. - software
View all Netgear WGT624v1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Reference Manual for the 108 Mbps Wireless Firewall Router WGT624 e. Now, turn on your computer. If software usually logs you in to your Internet connection, do not run that software or cancel it if it starts automatically. f. Verify the following: When you turn the router on, the power light goes on. The router's local LAN lights are lit for any computers that are connected to it. The router's Internet light or DSL modem. is lit, indicating a link has been established to the cable Note: For wireless placement and range guidelines, and wireless configuration instructions, please see Chapter 4, "Wireless Configuration." 2. Log in to the wireless router. Note: To connect to the router, your computer needs to be configured to obtain an IP address automatically via DHCP. If you need instructions on how to do this, please refer to Appendix C, "Preparing Your Network. a. Connect to the router by typing http://192.168.0.1 in the address field of Internet Explorer or Netscape® Navigator. Figure 3-4: Log in to the router b. For security reasons, the router has its own user name and password. When prompted, enter admin for the router user name and password for the router password, both in lower case letters. Note: The router user name and password are not the same as any user name or password you may use to log in to your Internet connection. 3-6 Connecting the Router to the Internet M-10153-01