Netgear WN604-100NAS Reference Manual - Page 77
Monitoring, System, Table 4-1, Appendix B, Related, Documents
View all Netgear WN604-100NAS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
NETGEAR Wireless N150 Access Point WN604 Reference Manual Under the Monitoring tab on the main menu, select System to view the System screen, shown in Figure 4-8 below. This screen shows the parameters listed in Table 4-1: Table 4-1. System Information Fields Field Description Access Point Information Access Point Name Ethernet MAC Address Wireless MAC address. Country/Region Indicates the NetBIOS name. The default name may be changed, if desired. Displays the Media Access Control address (MAC address) of the wireless access point's Ethernet port. Displays the Media Access Control address (MAC address) of the wireless access point's wireless card. Displays the domain or region for which the wireless access point is licensed for use. It may not be legal to operate this wireless access point in a region other than one of those identified in this field. Firmware Version Current Time The version of the firmware currently installed. Displays the current system time of the access point. Current IP Settings IP Address The IP address of the wireless access point. Subnet Mask Default Gateway The subnet mask for IP address of the wireless access point. The default gateway for the wireless access point communication. DHCP Client Enabled indicates that the current IP address of the AP was obtained from a DHCP server on your network. Disabled indicated a static IP configuration. Current Wireless Settings for 802.11b/bg/ng Operating Mode Identifies the 802.11 operating mode of the WN604. Channel/Frequency Identifies the channel the wireless port is using. 'Auto' is the default channel setting. (Channel frequencies used on each channel can be found in "Wire- less Communications"; a link to this article is in Appendix B, "Related Documents".). Management 4-9 v1.0, March 2010