Netgear WNDA4100 WNDA4100 Installation Guide - Page 1

Installation Guide N900 Wireless Dual Band USB Adapter WNDA4100 Package Contents N900 Wireless Dual Band USB Adapter Resource CD USB cable and adapter cradle Installation Estimated completion time: 10 minutes. 1. Insert the Resource CD in your computer's CD drive. If the CD main screen does not display, browse the files on the CD and double-click Autorun.exe. 2. Click Setup. The Software Update Check screen displays. 3. If you are connected to the Internet, click Check for Updates. If not, then click Install from CD. 4. Click I agree to accept the license agreement and then click Next. A message displays asking you to wait while software is installed. This might take a few minutes. Then you are prompted to insert your adapter. 5. Either insert the adapter into a USB port on your computer, or use the USB cable and adapter cradle provided to connect the adapter. The USB cable and adapter cradle can extend the range of your adapter and improve wireless reception. Insert the adapter in the cradle and attach the USB cable to the computer. Note: For best results, put the wireless adapter at least 4 feet (1 meter) away from your router. 6. Click Next. 7. NETGEAR Genie displays a list of wireless networks in your area. Join a Wireless Network You can join a wireless network from this NETGEAR Genie screen, or you can use Wi-Fi Protected Setup (WPS) if your wireless network supports it. • NETGEAR Genie: Click your wireless network to select it from the list, and then click Connect. If the network is secure, enter its password or network key. • WPS: Press and hold the WPS button on the side of the adapter for 2 seconds. Within 2 minutes, press the WPS button on your wireless router or gateway.