Nextar X3-08 User Manual - Page 21

Other possibilities - reset

Get Nextar X3-08 PDF manuals and user guides View all Nextar X3-08 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 21 highlights

Troubleshooting Problem Navigator cannot receive satellite signals or does not orient Possible Cause Unit may be inside a tunnel, inside a building, or tall buildings may obstruct the satellite signal Mapping SD card may be removed for music or photo functions Possible Solution Check for obstructions Re-install Mapping SD Card Satellite signal strength is unstable. Comes and goes. Rechargeable battery is weak Unit is moving side to side too much Signal is obstructed by buildings or other materials System software fails to function after entering a command Plug in power adaptor and charge Battery Secure unit Check and correct obstruction Turn the unit off and on again to reset using slide switch on rear. Other possibilities Static or other external interference may cause the unit to function abnormally. In order to recover normal status, please unplug the power supply cord and then plug it into the outlet again to reset the unit. If the problems still exist, please cut off the power supply and consult your service center or a qualified technician. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
21
Troubleshooting
Problem
Possible Cause
Possible Solution
Unit may be inside a tunnel,
inside a building, or tall
buildings may obstruct the
satellite signal
Check for obstructions
Navigator
cannot receive
satellite signals
or does not
orient
Mapping SD card may be
removed for music or photo
functions
Re-install Mapping SD
Card
Rechargeable battery is
weak
Plug in power adaptor and
charge Battery
Unit is moving side to side
too much
Secure unit
Signal is obstructed by
buildings or other materials
Check and correct
obstruction
Satellite signal
strength is
unstable.
Comes and
goes.
System software fails to
function after entering a
command
Turn the unit off and on
again to reset using slide
switch on rear.
Other possibilities
Static or other external interference may cause the unit to function abnormally. In order to
recover normal status, please unplug the power supply cord and then plug it into the
outlet again to reset the unit. If the problems still exist, please cut off the power supply
and consult your service center or a qualified technician.