Nikon R1 Wireless Close-Up Speedlight System Users Manual - English - Page 28
Procedures for close-up flash operation
View all Nikon R1 Wireless Close-Up Speedlight System manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Procedures for close-up flash operation 1 Installing batteries in the SU-800. 1 Slide open the battery chamber lid in the direction of the arrow. Battery chamber 2 Install the battery, then close the battery chamber lid by sliding it back into place. Use CR123A (3V) lithium batteries. Confirming the close-up mode setting Make sure that the Commander/Close-up select switch in the battery chamber is set to "Close-up" position. Replacing the battery The Low Battery-power Indicator blinks when the SU-800's ready-light does not come on within about 30 seconds of turning on the power or after the flash has fired. • Replace the battery. 28
28
Procedures for close-up flash operation
1
Installing batteries in the SU-800.
1
Slide open the battery chamber lid
in the direction of the arrow.
2
Install the battery, then close the
battery chamber lid by sliding it
back into place.
Use CR123A (3V) lithium batteries.
Confirming the close-up mode
setting
Make sure that the Commander/Close-up
select switch in the battery chamber is set
to “Close-up” position.
Replacing the battery
The Low Battery-power Indicator blinks
when the SU-800’s ready-light does not
come on within about 30 seconds of
turning on the power or after the flash has
fired.
•
Replace the battery.
Battery
chamber