NordicTrack 3000r Treadmill English Manual - Page 7

2. With the help of a second person, carefully tip the Uprights (20) and the Walking Platform (not shown) down to the position shown. Make sure that the Base Extension (90) remains in place. Attach the Base Extension (90) with four Extension Screws (87); start all four Extension Screws before tightening them. Next, attach the four Base Pads (83) to the base of the Uprights (20) in the locations shown with four 1" Tek Screws (82). Note: One replacement Base Pad may be included. Use the Base Pad to replace any Base Pad that becomes worn. With the help of a second person, carefully tip the Uprights (20) back to the vertical position. 2 83 82 20 87 90 83 82 87 3. Slide the two Upright Covers (75) onto the ends of the Pulse Bar (69). Align the holes in the lower ends of the Pulse Bar with the holes in the Uprights (20). Cut the tie securing the Pulse Wire (74) to the right Upright (20). Do not cut the indicated black tie. Connect the Pulse Wire to the Pulse Bar Wire (79). The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. Insert the wires down into the right Upright. Hold the Pulse Bar (69) against the Uprights (20). Do not drop the Pulse Bar into the Uprights. Attach the Pulse Bar with the four Pulse Bar Bolts (66) and four Star Washers (67). Be careful not to pinch the wires. Start all four Pulse Bar Bolts before tightening them. Slide the Upright Covers (75) over the Pulse Bar Bolts (66). 3 75 67 66 79 74 69 20 75 Do Not Cut 79 20 67 74 66 4. Press the Upright Covers (75) onto the Uprights (20). 4 Attach each Upright Cover with a 3/4" Screw (7). Be care- ful not to damage the wires in the right Upright. Wires 75 7 20 75 7 20 7