NordicTrack Apex 4600 Treadmill English Manual - Page 8

5. While pressing down on the Handrails (87), tighten eight Upright Bolts (86) and four 3/8" Star Washers (88) into 5 the Uprights (90, 95) and the Handrail (87) as shown. Be careful to avoid pinching the Upright Wire Harness (108). 86 Note: The CD Holder (38) and the Water Bottle Holder (43) are replaceable. If these parts become dislodged from the Console Base (80), simply press them back in. 38 88 80 43 86 90 87 88 86 95 6. Place the treadmill in the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 21). 6 Center the Frame (16) between the Uprights (90, 95). Tighten the eight Upright Bolts (86) in the lower ends of 16 the Uprights. 95 90 86 86 7. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place. The hex key is used to adjust the walking belt (see page 24). To protect the floor or carpet, place a mat under the treadmill. If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated 3/4" Screw (2) and the Access Door (58) from the underside of the Console Back (85) on the left side. 2. Connect the wire on the receiver (A) to the indicated wire extending from the Console Back (85). Hold the receiver so the small cylinder is oriented as shown. Attach the receiver to the plastic posts on the Access Door (58) with the two included small screws. 3. Make sure that no wires are pinched. Reattach the Access Door (58) with the 3/4" Screw (2). The other wires included with the receiver may be discarded. Wire 85 Small Screws Small Cylinder A 58 2 8