NordicTrack C 2200 English Manual - Page 12
See How To Turn On The Power - console
View all NordicTrack C 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
contacts, and your fingers must be touching the lower contacts- avoid moving your hands. When your pulse is detected, the Heart Rate indicator will flash, two or three dashes (- - -) will appear in the Incline/Heart Rate display, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds. 7 Turn on the fans if desired. To turn on the fans at low speed, press the FANS button. To turn on the fans at high speed, press the FANS button a second time. To turn off the fans, press the FANS button a third time. Note: Any time that the walking belt is stopped for a few minutes, the fans will automatically turn off. 8 When you are finished exercising, stop the walking belt and remove the key. Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest level. The incline must be at the lowest level when the treadmill is raised to the storage position or the treadmill will be damaged. Next, remove the key from the console and put it in a secure place. Note: If the displays and indicators on the console remain lit after the key is removed, the console is in the "demo" mode. Refer to page 23 and turn off the demo mode. When you are finished using the treadmill, unplug the power cord. HOW TO USE PRESET PROGRAMS 1 Insert the key fully into the console. See HOW TO TURN ON THE POWER on page 10. 2 Select one of the preset programs. When the key is inserted, the manual mode will be selected. To select a preset program, press the Select Program button repeatedly until the Power Burn, Endurance Run, Trail Runner, Pace Setter, Hiker's Hill, or Performance Peak indicator lights. For about six seconds after a program is selected, the Incline/Heart Rate display will flash the maximum incline setting for the program, and the Speed display will flash the maximum speed setting for the program. The Time/Pace display will show how long the program will last. The program display will show the first ten speed settings for the program. 3 Press the Start button or the Speed + button to start the program. A moment after the button is pressed, the treadmill will automatically adjust to the first speed and incline settings for the program. Hold the handrails and begin walking. Each program is divided into several time seg- ments of different lengths. (The Time/Pace display will show both the time remaining in the program and the time remaining in the current segment.) One speed setting and one incline setting are pro- grammed for each segment. (The same speed setting and/or incline setting may be programmed for consecutive segments.) The speed setting for the first segment will be shown in the flashing Current Segment column of the program display. (The incline set- tings are not shown in the pro- Current Segment gram display.) The speed settings for the next several segments will be shown in the columns to the right. 12