NordicTrack C 2200 English Manual - Page 7
Uprights 69 as shown. Connect the Upright Wire - parts
View all NordicTrack C 2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
4. Have a second person hold the Handrails (66) near the Uprights (69) as shown. Connect the Upright Wire 4 Harness (98) to the wires extending from the Console Base (81). Insert the connectors and the Upright Wire Harness into the hole in the right Upright. Set the Handrails (66) on the Uprights (69), being careful not to pinch the Upright Wire Harness (98). 66 81 98 69 5. Insert two Handrail Bolts (78) with Handrail Spacers (77) into the right Upright (69) and the right Handrail 5 (66). Be careful not to pinch the Wires. Make sure that the Handrail Spacers are flush against the right Upright with the thick sides facing the center of the treadmill, as shown in the inset drawing. Next, lift the right Handrail (66) slightly and align the Bolts with the holes in the Handrail. Thread the Bolts into the Handrail. Do not tighten the Bolts yet. 66 Attach the left Handrail (not shown) in the same way. Tighten all four Handrail Bolts (78). 69 77 77 78 Thick Side 6. Make sure that all parts are properly tightened before you use the treadmill. Note: If there is a thin sheet of clear plastic on the hood decal, remove it. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 27). To protect the floor or carpet from damage, place a mat under the treadmill. 7