NordicTrack C 7.5 Elliptical English Manual - Page 29

HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest level, the drive belt may need to be adjusted. To adjust the drive belt, first unplug the power cord. Using a standard screwdriver, remove the Shield Cover (75) and the Shield Cover Cap (118). 118 75 See EXPLODED DRAWING C on page 35. Identify the Left and Right Shields (73, 74). Remove the M4 x 19mm Screws (5) and the M4 x 48mm Screw (107) from the Left and Right Shields. Then, remove the Right Shield. Next, locate and loosen the Idler Screw (89). Tighten the Belt Adjustment Screw (91) until the Drive Belt (113) is tight. Then, retighten the Idler Screw. 113 See assembly step 15 on page 15. Remove the Right Leg Outer and Inner Covers (69, 83). See assembly step 12 on page 13. Remove the Right Pedal Arm (58) from the Right Upper Body Leg (60). Next, remove the M8 x 16mm Screw (95), the Large Axle Cover (53), and the M8 Washer (not shown) from the right Crank Arm (20). Then, carefully remove the Right Roller Arm (59) and the Right Pedal Arm (58) from the elliptical. 89 91 Reattach the parts that you removed. Then, plug in the power cord. 95 53 20 59 58 29