NordicTrack C 700 Treadmill User Manual - Page 7
Assembly - treadmill
View all NordicTrack C 700 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
ASSEMBLY • Assembly requires two persons. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps. • After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild, non-abrasive cleaner. • Left parts are marked "L" or "Left" and right parts are marked "R" or "Right." • To identify small parts, see page 6. • Assembly requires the following tools: the included hex keys one adjustable wrench one Phillips screwdriver scissors needlenose pliers To avoid damaging parts, do not use power tools. 1. Make sure that the power cord is unplugged. Locate the Upright Wire (91) bundled around the Base (29). Cut the plastic tie securing the Upright Wire. Route the Upright Wire into the Base and out of the indicated hole. See the inset drawing. Cut the plastic tie near the Upright Wire (91). Be careful not to damage the Upright Wire. 1 29 Cut Hole 91 Tie Cut 91 2. With the help of a second person, tip the treadmill onto its right side. Attach a Wheel (93) to the Base (29) with a 3/8" x 2 1/2" Bolt (7) and a 3/8" Nut (9). Do not overtighten the Nut; the Wheel must turn freely. Attach a Thick Base Pad (37) and a Thin Base Pad (92) to the Base (29) in the locations shown with four #8 x 3/4" Tek Screws (13). Be careful not to overtighten the Screws. Press a Base Cap (87) into the Base (29). 2 87 37 13 7 7 29 13 92 93 9