NordicTrack C 950i Treadmill English Manual - Page 16

14. Identify the Right Handrail Cover (85). Set the Right Handrail Cover on the right Handrail (86). Start two #8 x 3/4" Truss Head Screws (14) into the bottom of the Handrail Cover; do not fully tighten the Screws. Next, slide the Right Handrail Cover (85) forward until it rests against the console assembly (F). Then, tighten the two #8 x 3/4" Truss Head Screws (14); do not over tighten the Truss Head Screws. Then, attach the Right Bottom Handrail Cover (88) with two 8 x 3/4" Truss Head Screws (14). Attach the Left Handrail Cover (79) and the Left Bottom Handrail Cover (87) in the same way. 14 79 86 14 87 14 85 F 14 86 88 14 15. Note: If the treadmill is assembled on a smooth surface, it may roll forward during this step. Raise the Frame (56) to the upright position. Have a second person hold the Frame until step 17 is completed. Remove the two 5/16" x 3/4" Screws (4) from the Latch Crossbar (38). Orient the Latch Crossbar (38) as shown. Make sure that the "This side toward belt" sticker (K) is facing the treadmill. Attach the Latch Crossbar to the brackets (L) on the Frame (56) with the two 5/16" x 3/4" Screws (4) that you just removed and two 5/16" Star Washers (11). 15 L 11 4 56 38 K L 11 4 16