NordicTrack C 950i Treadmill English Manual - Page 18

18. Firmly tighten the four 3/8" x 2 1/4" Screws (7), the two 3/8" x 1 3/4" Screws (62), and the 18 two 3/8" x 1 1/4" Screws (63). Do not over- tighten the Screws. Set the Left Inner Base Cover (113) onto the lower end of the Left Upright (89). Then, slide the Left Base Cover (82) downward and press it 90 onto the Left Inner Base Cover. Next, set the Right Inner Base Cover (114) onto the lower end of the Right Upright (90). Then, 83 slide the Right Base Cover (83) downward and press it onto the Right Inner Base Cover. 63 7 89 82 113 63 114 62 7 62 19. P ress the two tabs (not shown) on the Tablet Holder (103) into the slots (O) in the console assembly (F). Then, attach the Tablet Holder (103) to the console assembly (F) with four #8" x 5/8" Machine Screws (100). Tip: Start the two upper Machine Screws first, and then start the two lower Machine Screws. Do not overtighten the Machine Screws. IMPORTANT: The Tablet Holder (103) is designed for use with most full-size tablets. Do not place any other electronic device or object in the Tablet Holder. 19 103 Start First 100 100 O F 20. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 29 and 30). Note: Extra hardware may be included. 18