NordicTrack Cx 1050 Elliptical User Manual - Page 7
on the Left Upper Body Arm 118. Hold the Left Upper
View all NordicTrack Cx 1050 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. Slide a Weld Spacer (119) onto the axle on the left side of the Upright (2); make sure that the open side of the Weld Spacer is facing the Upright. Next, apply a small amount of grease to the axle. Identify the Left Upper Body Arm (118), which is marked with a sticker. Remove the Upper Body Leg (31) from the Left Upper Body Arm. Apply a small amount of the included high-temperature lubricant to a paper towel, and rub a thin film of the lubricant onto the Upper Body Leg. Then, reinsert the Upper Body Leg into the Left Upper Body Arm. Slide a Handlebar Cover (26) onto the indicated tube on the Left Upper Body Arm (118). Hold the Left Upper Body Arm with one hand, hold the Upper Body Leg (31) with your other hand, and slide the Left Upper Body Arm onto the axle on the left side of the Upright (2). Then, extend the Upper Body Leg until it rests on the Ramp (3). Repeat this step with the Right Upper Body Arm (128). 6. Have another person hold the Left Handlebar (24) near the Upright (2). Connect the left Pulse Sensor Wire (20) to the Pulse Extension Wire (114). Next, slide a Handlebar Cap (127) onto the lower end of the Left Handlebar. Slide the upper end of the Left Handlebar (24) into the tube on the front of the Upright (2), while sliding the lower end of the Left Handlebar onto the axle on the left side of the Upright. Attach the upper end of the Left Handlebar with two M8 x 42mm Button Bolts (85) and two M8 Jam Nuts (86); be careful not to damage the Wires (20, 114) as you insert the Button Bolts. Make sure that the Jam Nuts are resting in the hexagonal holes in the Left Handlebar. Attach the lower end of the Left Handlebar with an M8 x 38mm Button Bolt (105) and an M8 Jam Nut (86). Then, press the tabs on the Handlebar Cap (127) into the left Handlebar Cover (26). Attach the Right Handlebar (23) in the same way. 7. Hold the halves of the Upper Handlebar Cover (25) around the tube on the front of the Upright (2); be careful not to damage the Wires (not shown). Attach the Upper Handlebar Cover with an M4 x 12mm Round Head Screw (96). 5 Grease 26 118 Cutout 119 Tube 128 2 3 Lubricate 31 6 85 114 20 23 86 2 24 Cutout 127 26 105 86 7 25 2 25 96 7