NordicTrack Cx 1600 Elliptical English Manual - Page 5

ASSEMBLY Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the in- cluded tools, assembly requires a Phillips screwdriver , an adjustable wrench , and a rubber mallet . As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the hardware kit, check to see if it has been preassembled. M8 Small Washer (18)-4 M10 Split Washer (85)-20 Wave Washer (88)-4 M10 Washer (67)-14 M8 Washer (69)-4 M4 x 16mm Screw (47)-6 M4 x 19mm Screw (57)-2 M8 x 19mm Button Screw (56)-4 M8 Nylon Locknut (72)-4 M10 Nylon Locknut (70)-2 M8 x 38mm Button Bolt (58)-4 M8 x 55mm Bolt Set (92)-2 M10 x 13mm Button Screw (54)-14 M10 x 25mm Patch Screw (48)-4 M10 x 65mm Bolt Set (94)-2 M10 x 116mm Carriage Bolt (38)-2 M10 x 123mm Button Screw (87)-2 Thrust Washer (66)-4 5